Wherever the car is broken, it will be repaired. This is not a normal idea. But everything has a special time,
Once there is a problem with which part of the car, it is best to carry out a complete set of replacement?
That is the clutch three-piece set, the three-piece set includes: clutch plate, pressure plate, release bearing.
Some car owners may say that the car is only broken by the clutch plate, why should the other two be replaced?
The replacement cost is even higher. The editor suggests that car owners should not worry about the cost of changing the three-piece suit at one time. Why?
A car owner complained that the clutch plates and flywheel bearings were replaced only last month, and now the car has problems to replace the pressure plate. Thinking about delaying work for at least half a day, I was in a bad mood.
According to the editor's calculation of a fee for the car owner, not to mention the time delay, the cost is an extra maintenance fee than before. Basically, the maintenance cost of changing the clutch plate and the pressure plate basically ranges from 200 yuan.
The reason for changing the three-piece suit is that when our car is driving, when changing gears or when the car is climbing.
The parts related to the clutch interact together. If there is a problem with the clutch plate, the pressure plate cannot last long.
Many times, the 4S shop or repair shop staff will tell you that the clutch plate needs to be replaced, and it is best to replace the pressure plate together. But some will tell you that it is good to change a piece, and others are not bad. Tell you it's not bad.
The maintenance staff are ignorant of you, and look forward to your visit again soon. It is a means of repairing and pressing the village, and the fee is charged once when you come.
It would have been a problem and only cost one repair. Why do you have to feel bad about replacing a whole set, but this time one is broken, and the other is broken within a month, and the repair fee will be paid several times separately.
How can I tell if the clutch plates need to be replaced?
1. Under normal circumstances, when the power transmission is sluggish during gear shifting, the car cannot run at high speed.
2. You can only run 80-90 kilometers when you step on the accelerator to the end, because the clutch slips;
3. When starting in first gear, the car has a jolting feeling in the front and rear; when stepping on, lifting the clutch, there is a jerky feeling, etc.
4. If these conditions occur, replace the clutch plate and pressure plate.
5. It can be seen that the more the clutch is used, the higher the speed, the car feels boring when climbing a hill, and even in severe cases, the car can smell a burnt smell after driving for a period of time.
6. Our simple method for manual inspection: shift to 1st gear, pull up the hand brake or step on the brake, and then start. If the engine doesn't stall, it needs to be replaced.
How to reduce wear and save replacement costs?
1. Do not step on the clutch when driving, or put your foot on the clutch pedal for a long time.
2. Do not always use half-linkage to control the speed of the vehicle, or use half-linkage to stop the car.
The above conditions make the clutch often in the engaged, disengaged or semi-slip state.
Accelerated the wear of the friction plate and pressure plate of the clutch, so that the power of the engine cannot be fully transmitted to the driving wheels, resulting in fuel consumption and expensive vehicles.
Usually we can also replace it according to the mileage and the degree of wear and tear.
If it is a car that is driven frequently, it is recommended to replace the clutch plate, pressure plate, and release bearing together. Manufacturers are also equipped with accessories when they leave the factory, but retail stores or 4S stores are split and sold to meet everyone's needs.